Stainless Steel Pull Cord Switch Used for Emergency Stops1no 1nc /2no 2nc Manual Operation Ktl2-II

• Product Name: Stainless Steel Pull Cord Switch
• Model: Ktl2-II
• Angle of Action: 30°
• Shipping Cost: Estimated freight per unit.: about shipping cost and estimated delivery time.
• Currency: US$
• Return&refunds: You can apply for a refund up to 30 days after receipt of the products.
• Model NO.: KTL2-II
• Limit Angle: 75°
• Number of Contacts: 1no 1nc /2no 2nc
• Transport Package: Carton
• Specification: 5kg
• Trademark: VKSELE
• Origin: Zhejiang, China
• Package Size: 25.00cm * 20.00cm * 15.00cm
• Package Gross Weight: 5.000kg

Product Description

Product Description

This machine is used for emergency stops in the event of an accident at a tape transport site.
Working principle:
When an emergency occurs at the belt transport site, pull the wire rope tied to the lifting lug to make the slider and switch in the machine function and send out a stop signal, Release the wire rope and press the reset bar before the reset.
Product Parameters :

Model	KTL2-II	Angle of action	30°
Limit Angle	75°	Ambient temperature	-30°C-+60°C
Number of contacts	1NO 1NC /2NO 2NC	Action force	10KG
Frequency	50Hz/60Hz	Relative humidity	≥85%
Reliability	>10^6times	Protection	IP65

Installation And Use:
The switch is balanced on the fixing bracket of the frame:Tie the wire rope to the pull ring at the upper and lower ends of theThe rope pressure should be suitable to ensure the reliable reset of the switch;The pulling rope is arranged in the parallel direction of the tape, and a lifting ring is added every 3 meters;pull rope switch, and the wire rope on each side shall not exceed 40m(it shall be shortened to 25 meters when there is a slope):