| Customization: | Available |
|---|---|
| Protection: | IP65 |
| Max. Voltage: | 24-380V |
|
Still deciding? Get samples of US$ 500/Piece
Order Sample
|
| Shipping Cost: | Contact the supplier about freight and estimated delivery time. |
|---|
| Payment Methods: |
|
|---|---|
| Support payments in USD |
| Secure payments: | Every payment you make on Made-in-China.com is protected by the platform. |
|---|
| Refund policy: | Claim a refund if your order doesn't ship, is missing, or arrives with product issues. |
|---|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
Overview:
This product is suitable for detecting the slippage between the tape and the main roller in the operation of the belt conveyor
to prevent malicious accidents caused by slippage, and is also suitable for interlocking or stopping multiple tape machines.
Working principle:
After the delay, the belt speed signal is detected by two photoelectric sensors and then input into the control box, the actual
belt speed is displayed and calculated by the microcomputer (CPU) and sent to the monitor, while comparing with the preset
belt speed, when the belt speed is lower than the set value, the controller displays the belt speed and makes the corresponding
relay When the belt speed is lower than the set value, the controller will display the belt speed and make the corresponding
relay send out a signal, and the corresponding indicator light (red) will be on, indicating that the belt is slipping; on the contrary,
when the actual belt speed is higher than the set value, the controller will enter normal operation and the corresponding
indicator light (green) will be on. The relay is released.
Installation And Use:
The control box should be installed on the frame of the tape machine or on the wall near the monitoring head (not more
than 100m) the sensing head is installed on the belt under the tape machine and the belt is running smoothly. There are
two ways to install the sensing head: 1. Weld the sensing head under the tape machine bracket beam,
2. Weld 40*40 angle steel micro beam at the site itself, punch two holes (16) in the middle of the angle steel, the hole
spacing see the spacing of the tape machine pulley, the angle steel will be fixed.Product Display:
){kind=link}