Wksklt2-2 Two Way 1no1nc Type Automatic Type Pull Cord Switch

• Protection: IP65
• Max. Voltage: 24-380V
• Action Angle: 30°
• Shipping Cost: Estimated freight per unit.: about shipping cost and estimated delivery time.
• Currency: US$
• Return&refunds: You can apply for a refund up to 30 days after receipt of the products.
• Model NO.: WKSKLT2-2
• Ambient Temperature: -30~+60ºC
• Switch Potency: AC/DC24-380V
• Transport Package: Carton
• Specification: WKSKLT2-2
• Trademark: VKSELE
• Origin: Wenzhou
• Production Capacity: 1000pieces/Week
• Package Size: 25.00cm * 20.00cm * 18.00cm
• Package Gross Weight: 3.000kg

Product Description

 

Product Description

Two-way Pull Cord switch is widely used in steel, cement, power plants, mines and other plants with belt conveyors, the product is installed on both sides of the tape conveyor, is used in the tape conveyor emergency stop a kind of protection switch, pull the wire rope at any point within the switch operating distance, cut off the operating circuit to stop the whole line, to achieve the protection of the tape machine and personal safety.
Working principle:
When an emergency occurs at the tape transport site, pull the wire rope tied to the lugs to make the slider in the machine work with the switch to signal a stop. Release the wire rope and press the reset bar to reset.

Product Parameters

Product Name	Pull rope switch	Model	HFKLT2-II / KLT2
Reset mode:	Manual and automatic reset	Environmental temperature	-30ºC--- +60ºC
Relative Humidity	less than 85%	No. of contacts	1NO1NC /2NO2NC
Action Angle	30°	Action force	10kg
Limit  Angle	60°	Current	1.5A
Reliability	>10^6 times	Contact capacity	AC380V /DC220V

 Structure characteristics:
The switch is made of high quality travel switch, with long use mission.
Good sealing, with the advantages of dustproof, shockproof, anti-corrosion, etc.
The housing adopts cast aluminum casting, light weight and high hardness.

 

Installation And Use:

The switch is balanced on the fixed bracket of the frame; Tie the wire rope to the pull ring at the upper and lower ends of
the pull rope switch, with the wire rope not exceeding 40 meters on each side (should be shortened to 25 meters when
there is a slope). The pull rope pressure should be appropriate to ensure reliable reset of the switch. setting the pull rope
along the parallel direction of the tape, adding a lifting ring every 3 meters.

Detailed Photos

Packaging & Shipping