Non-Contact Integrated Speed Detectors Switch

• Protection: IP65
• Max. Voltage: 24-380V
• Action Angle: 30°
• Shipping Cost: Estimated freight per unit.: about shipping cost and estimated delivery time.
• Currency: US$
• Return&refunds: You can apply for a refund up to 30 days after receipt of the products.
• Model NO.: WKSDH-R
• Ambient Temperature: -30~+60ºC
• Switch Potency: AC/DC24-380V
• Transport Package: Carton
• Specification: WKSDH-R
• Trademark: VKSELE
• Origin: Wenzhou
• Production Capacity: 1000pieces/Week
• Package Size: 45.00cm * 42.00cm * 32.00cm
• Package Gross Weight: 10.000kg

Product Description

Overview:

This product is suitable for detecting the slippage between the tape and the main roller in the operation of the belt conveyor
to prevent malicious accidents caused by slippage, and is also suitable for interlocking or stopping multiple tape machines.
Working principle:
After the delay, the belt speed signal is detected by two photoelectric sensors and then input into the control box, the actual
belt speed is displayed and calculated by the microcomputer (CPU) and sent to the monitor, while comparing with the preset
belt speed, when the belt speed is lower than the set value, the controller displays the belt speed and makes the corresponding
relay When the belt speed is lower than the set value, the controller will display the belt speed and make the corresponding
relay send out a signal, and the corresponding indicator light (red) will be on, indicating that the belt is slipping; on the contrary, 
when the actual belt speed is higher than the set value, the controller will enter normal operation and the corresponding
indicator light (green) will be on. The relay is released.

 

Installation And Use:

The control box should be installed on the frame of the tape machine or on the wall near the monitoring head (not more
than 100m) the sensing head is installed on the belt under the tape machine and the belt is running smoothly. There are
two ways to install the sensing head: 1. Weld the sensing head under the tape machine bracket beam,
2. Weld 40*40 angle steel micro beam at the site itself, punch two holes (16) in the middle of the angle steel, the hole
spacing see the spacing of the tape machine pulley, the angle steel will be fixed.
Product Display: